Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Lincroft Roofing & Maintenance has been installing skylights in Lincroft for 12 years — every one leak-free.
Tubular skylights are the alternative for spaces where a full skylight isn't practical — small bathrooms, closets, interior hallways. A 10-inch or 14-inch dome on the roof captures daylight through a reflective tube that channels it to a ceiling diffuser. Smaller roof penetration, simpler flashing, and effective daylighting in spaces a traditional skylight can't reach.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Roof Opening & Framing
We cut the roof deck opening through the sheathing and shingles, then frame a structural curb between the rafters with doubled lumber. Headers distribute the load around the opening. The curb provides a solid, level base for the skylight unit.
Flashing & Waterproofing
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Install & Insulate
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Lincroft Customers Say
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
Why Choose Lincroft Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Code Compliant
Every skylight installation meets NJ building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.